Product Reviewed 15 times. Only most recent 100 shown
|
Rating Stars
|
Reviewer
|
Date
|
|
Thomas L From New York, NY |
12/03/25 |
|
AC extension of a small neon sculpture ps.
|
|
|
nicholas v From Elmhurst, IL |
10/09/25 |
|
|
Samer D From Garden Grove, CA |
09/03/25 |
|
This product was used to build a stereo unbalanced-to-balanced adapter cable: a 3.5 mm stereo plug (red = left, black = right, shield = ground) wired into an Extron 5-pin Phoenix block with jumpers tying L− and R− to ground.
|
|
|
Thomas T From WILMINGTON, NC |
10/17/24 |
|
|
Mike M From Centennial, CO |
08/14/24 |
|
Will use for signal cable in guitar amp.
|
|
Erik J From Des Moines, IA |
05/10/24 |
|
Making patch cables for my reocording studio.
|
|
|
Kyle P From Jacksonville, TX |
02/01/23 |
|
This cable is perfect for custom wiring inside an equipment rack.
|
|
Edward S From Mesquite, TX |
08/31/22 |
|
|
Roger P From La Mesa, CA |
07/20/22 |
|
|
Benjamin M From Houston, TX |
11/30/20 |
|
|
Bruce T From Reno, NV |
08/12/20 |
|
I'm using it to make a cable for my morse code key. I attached a TRS plug. It worked fine, but I would have liked it better if it were a little more flexible.
|
|
Clayton N From WHITE HALL, MD |
08/06/20 |
|
This cable gauge is extremely too thin to be used properly for XLR cables. I feel deceived by it’s advertising saying that it can be used for this. On top of that, the service I received in efforts to solve this issue was extremely underwhelming. I would like to exchange it for thicker how’ve cabling or return for my money back.
|
|
|
Joseph C From HAUPPAUGE, NY |
07/07/20 |
|
Good quality. If using with XLR connectors, use heat shrink tubing on the end so the strain relief clamp of the connector can grab hold of the cable,
|
|
|
Robert S From Atlanta, GA |
07/03/19 |
|
|
Scott S From LEESBURG, VA |
05/02/19 |
|
Used for wiring a Waterbug water alarm to extend the distance over the wire which comes with it.
|
